| View previous topic :: View next topic |
| Author |
Message |
connloyalist
 Joined: 22 Jul 2020 Posts: 381 Location: the Netherlands
|
 Posted: Sun Sep 28, 2025 4:29 pm Post subject: PX625 camera modified to 1.5v - power curve? |
|
 Posted: Sun Sep 28, 2025 4:29 pm Post subject: PX625 camera modified to 1.5v - power curve? |
|
|
connloyalist wrote:
I am looking at an Olympus OM-1 (not the modern one). The OM-1 used/uses used the PX625 1.35 volt mercury battery which you can't get anymore (alternatives available). The seller says the light meter was adjusted to use 1.5 volts and a diode was put in the power wire.
First question. Correct me if I am wrong but as I understand a diode allows voltage to travel in one direction only? What could be the relevance in this application?
Second question: the original PX625 has a very flat power curve over time which, as I understand it, means camera's that use these batteries generally don't have circuitry to compensate for a drop in voltage as the battery gradually depletes. Wouldn't that imply that adjusting the camera to 1.5 volts for the lithium LR9/PX625a will only make it accurate with a more or less fresh battery since the voltage in these lithium batteries drops as they are gradually run down?
Regards, C. |
|
| Back to top |
|
 |
RokkorDoctor
 Joined: 27 Nov 2021 Posts: 1562 Location: Kent, UK
Expire: 2025-05-01
|
 Posted: Sun Sep 28, 2025 5:42 pm Post subject: Re: PX625 camera modified to 1.5v - power curve? |
|
 Posted: Sun Sep 28, 2025 5:42 pm Post subject: Re: PX625 camera modified to 1.5v - power curve? |
|
|
RokkorDoctor wrote:
| connloyalist wrote: |
I am looking at an Olympus OM-1 (not the modern one). The OM-1 used/uses used the PX625 1.35 volt mercury battery which you can't get anymore (alternatives available). The seller says the light meter was adjusted to use 1.5 volts and a diode was put in the power wire.
First question. Correct me if I am wrong but as I understand a diode allows voltage to travel in one direction only? What could be the relevance in this application?
Second question: the original PX625 has a very flat power curve over time which, as I understand it, means camera's that use these batteries generally don't have circuitry to compensate for a drop in voltage as the battery gradually depletes. Wouldn't that imply that adjusting the camera to 1.5 volts for the lithium LR9/PX625a will only make it accurate with a more or less fresh battery since the voltage in these lithium batteries drops as they are gradually run down?
Regards, C. |
Very likely it uses the voltage drop over diode when used in forward voltage configuration, but for reducing the 1.5V down to 1.35V that only really works if they have used the correct type of Schottky diode (a regular diode has much too high a forward voltage drop).
And yes, this trick only works with a relatively fresh 1.5V battery. Your best bet is to use a silver-oxide 1.55V battery rather than a standard 1.5V alkaline battery; silver-oxide batteries maintain a more constant voltage as they age, and especially when used in the cold.
By the way, the LR9 and PX625a you mentioned are alkaline batteries, not lithium batteries. I would recommend an S625PX silver-oxide battery, also known as SR09 / PX625S / RPX625S / V625U / EPX625BP. _________________ Mark
SONY A7S, A7RII + dust-sealed modded Novoflex/Fotodiox/Rayqual MD-NEX adapters
Minolta SR-1, SRT-101/303, XD7/XD11, XGM, X700
Bronica SQAi
Ricoh GX100
Minolta majority of all Rokkor SR/AR/MC/MD models made
Sigma 14mm/3.5 for SR mount
Tamron SP 60B 300mm/2.8 (Adaptall)
Samyang T-S 24mm/3.5 (Nikon mount, DIY converted to SR mount)
Schneider-Kreuznach PC-Super-Angulon 28mm/2.8 (SR mount)
Bronica PS 35/40/50/65/80/110/135/150/180/200/250mm |
|
| Back to top |
|
 |
connloyalist
 Joined: 22 Jul 2020 Posts: 381 Location: the Netherlands
|
 Posted: Sun Sep 28, 2025 6:06 pm Post subject: Re: PX625 camera modified to 1.5v - power curve? |
|
 Posted: Sun Sep 28, 2025 6:06 pm Post subject: Re: PX625 camera modified to 1.5v - power curve? |
|
|
connloyalist wrote:
| RokkorDoctor wrote: |
Very likely it uses the voltage drop over diode when used in forward voltage configuration, but for reducing the 1.5V down to 1.35V that only really works if they have used the correct type of Schottky diode (a regular diode has much too high a forward voltage drop).
And yes, this trick only works with a relatively fresh 1.5V battery. Your best bet is to use a silver-oxide 1.55V battery rather than a standard 1.5V alkaline battery; silver-oxide batteries maintain a more constant voltage as they age, and especially when used in the cold.
By the way, the LR9 and PX625a you mentioned are alkaline batteries, not lithium batteries. I would recommend an S625PX silver-oxide battery, also known as SR09 / PX625S / RPX625S / V625U / EPX625BP. |
Thank you, very instructive. The reason I was thinking lithium was because of the L in LR9. Good to know.
Truth be told, I don't need another film camera but sometimes you see something interesting pop up and think "ooh, that's interesting". For example, when it says it has been serviced and in the case of an OM-1 or OM-2 if the prism problem has been taken care of. File this under the category "GAS attack"
Regards, C. |
|
| Back to top |
|
 |
Farside
 Joined: 01 Sep 2007 Posts: 6579 Location: Ireland
Expire: 2013-12-27
|
 Posted: Wed Oct 22, 2025 1:09 am Post subject: Re: PX625 camera modified to 1.5v - power curve? |
|
 Posted: Wed Oct 22, 2025 1:09 am Post subject: Re: PX625 camera modified to 1.5v - power curve? |
|
|
Farside wrote:
| connloyalist wrote: |
| RokkorDoctor wrote: |
Very likely it uses the voltage drop over diode when used in forward voltage configuration, but for reducing the 1.5V down to 1.35V that only really works if they have used the correct type of Schottky diode (a regular diode has much too high a forward voltage drop).
And yes, this trick only works with a relatively fresh 1.5V battery. Your best bet is to use a silver-oxide 1.55V battery rather than a standard 1.5V alkaline battery; silver-oxide batteries maintain a more constant voltage as they age, and especially when used in the cold.
By the way, the LR9 and PX625a you mentioned are alkaline batteries, not lithium batteries. I would recommend an S625PX silver-oxide battery, also known as SR09 / PX625S / RPX625S / V625U / EPX625BP. |
Thank you, very instructive. The reason I was thinking lithium was because of the L in LR9. Good to know.
Truth be told, I don't need another film camera but sometimes you see something interesting pop up and think "ooh, that's interesting". For example, when it says it has been serviced and in the case of an OM-1 or OM-2 if the prism problem has been taken care of. File this under the category "GAS attack"
Regards, C. |
This sums it up quite well.
https://cameragx.com/2020/02/12/replacement-for-mercury-batteries-2/
And here's more than you would ever want to know about it...
https://buhla.de/Foto/batt-adapt-US.pdf
For my OM-1 I bought a few zinc-air cells just to see if they work (they do) and a proper adapter with a diode built in.
I have a small stock of silver SR44s to use with it, and for other cameras that accept them.
I've tried to find the maker of the adapter, it was about €20 plus shipping.
<edit> Found it. You could email the guy and ask him what his current price is...
battery.adapter@online.nl I don't have a website address.
His name is Frans de Gruijter _________________ Dave - Moderator
Camera Fiend and Biograph Operator
If I wanted soot and whitewash I'd be a chimney sweep and house painter.
The Lenses of Farside (click)
BUY FRESH FOMAPAN TO HELP KEEP THE FACTORY ALIVE ---
Foma Campaign topic -
http://forum.mflenses.com/foma-campaign-t55443.html
FOMAPAN on forum -
http://www.mflenses.com/fs.php?sw=Fomapan
Webshop Norway
http://www.fomafoto.com/
Webshop Czech
https://fomaobchod.cz/inshop/scripts/shop.aspx?action=DoChangeLanguage&LangID=4 |
|
| Back to top |
|
 |
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|