MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

DIY colour attempt #8 - Bootle Church and Haverigg Pool
View previous topic :: View next topic  


Reply

Hmm, not sure what went wrong here, I used an 8 year expired Lloyds pharmacy roll of 200 ISO, came out with wierd colours and tons of grain. I think it's just a case of the film being old and not stored properly. Konica FT-1 with 1.8/40 and 2.8/24 Hexanons.


#1

#2

#3

#4

#5

#6

#7

#8

#9

#10

#11

#12

#13

#14

#15

#16

#17

#18

#19

#20

#21


Reply

Here's some I played with, wasn't able to correct the colours properly though:


#1

#2

#3

#4

#5


Reply

The lomo crowd would love your shots Wink


Reply

+1 on lomo Laughing sorry for wasted time.


Reply

Wow! That are weird colors! Smile
Interesting effect!

Maybe also wrong temperature during development?


Reply

Well, there are multiple issues going on with this film so I doubt temperature was the problem.

Perhaps my bleach is getting tired (it's done a dozen rolls now) and there was insufficient bleaching?

There seems to me, to be very little green in the images, the red and blue is there but the green is missing, hence the wierd colours.

Also, there were yellow, magenta and cyan casts on various frames in various places.

I think what has happened is the film was heat damaged due to being old and not stored properly, the green layer had lost sensitivity. Add in some slight under-bleaching et voila - the colours are all over the place. The high grain level is a bit more mysterious, that is probably a combination of this being a grainy cheap crappy film to begin with and the detrimental effects of being expired many years.


Reply

Actually, I like it Laughing


Reply

Excalibur wrote:
The lomo crowd would love your shots Wink


Can't be lomo, the composition is too good. Wink


Reply

Thanks guys. I suppose the difference between lomography and what I did is simply that the lo-fi aspect of my shots is un-intentional whereas the lomo people do it deliberately.

I used the colour restoration and colour fading settings in vuescan then messed around with the colours in photoshop, trying to get them somewhere close to realistic, I think if I'd just scanned them clean without the colour fixing, they would be really wacky with wierd colours.


Reply

thats not bad at all. you better find out Ian. and share again. what's behind those colors


Reply

Thanks IAZA. I'm not sure of what really happened, but I will keep everyone informed about further colour work and maybe I'll run into issues like this again which will make it clear what the problem is/was.


Reply

It might be worthwhile shooting a fresh, in date, roll of film, just to see if it is the film or a problem with the process. Certainly the effects are interesting! Laughing


Reply

Two great minds mate...

I did exactly that and it seems it must have been the old film being buggered:

http://forum.mflenses.com/viewtopic,p,1274870.html#1274870


Reply

They look a bit like the results from colour infrared film.


Reply

Are you shure that Vuescan doesn't produce this ? I mean are the proper settings ? for this emulsion?


Reply

Yes, definitely not vuescan, without the colour fading and colour fixing settings turned on the colours were a lot more wacky, and I still then had to play with them in Photoshop, saturation was low and had to be increased and I had to remove a lot of colour casts.