This is in Exakta mount, and i was able to unscrew the mount off after unscrewing the 3 small screws on the flange neck right under the Exakta flange. Having done that I found that it was constructed very differently inside from other Exakta mounts I have seen; the lens mount besides being screwing down -was screwed by the 3 small screws I mentioned before to an inner sleeve . This sleeve does not rotate as it has a slot that makes it slide in and out, but not around.
The throat i.e. the part that the Exakta mount screws on is akin to a uni-adapter .Its a tad wider than a T-mount,and a tad smaller than a T-mount with the inner ring removed.
The main objective of all of this was to see how I could convert to or mount a M42 mount, and maintain infinity. Shaving the back of the mount is out of question as the back of the mount is thin enough where shaving maybe ill advised.
I have posted some images of the partial disassemble-I am keen on hearing what your experience/advise/suggestions may be, specially if you've had a similar lens you've worked on
Whats the diameter of the thread ? _________________ I like Pentax DSLR's, Exaktas, M42 bodies of all kinds, strange and cheap Japanese lenses, and am dabbling in medium format/Speed Graphic work.
The diameter of the inner threaded end is 44mm
Thanks
P.S-Check my other new old lens a SUN ,Linked here -looks like following your lead .Although I know I could never never produce the quality of images you do-they're super.
Its got a focus ring that wont budge so far. I've managed to loosen and free up the aperture blades. I was able to test it mounted on bellows -it actually works quite good and with infinity and a much closer "close focusing" distance.
pps-edited stuff about miranda mount out-too much happy sauce when I wrote that
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum