MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

Photos from horrid negatives
View previous topic :: View next topic  


Reply

Well, my third roll to develop was nightmare. The film was Kentmere 400. It is thinner than Tri-X, which caused extreme handling difficulties in the changing bag.
It just did not want to stay in the reel, or it would bunch up after I had wonud on a few frames.
Then I would have to pull the film out ansd start over, manhandling it again. I was reeling with the film still in the little can. Finally, I reel until I feel a stop in the can, so I cut it off, but it will not finish reeling. Had to start over, and over, and over, creasing the film, and tearing a sprockey hole.
Anyhow, I get it loaded and into the Paterson tank. I messed up the development, too, by setting the tank on its covered top for several seconds, draining the devloper away from the film for that amount of time. Oh no! I turn it back over and continue the drill.
Finally, after washing, I pull the film and it is only 15 negatives. The rest stayed in the cassette!
And, the negatives were horrid. I did salvage three prints. I hope the grain cl;umpiness is a result of the messy development, and not a trait of the film. Anyhow, here are some mightily touched up pics from thopse terribly maltreated negatives, shot on my FED-2d, Industar-50:

This one required the least spotting of defects:



This one required at least 500 spot fixes (or so it seemed):



This one had sweeping slashes through it:



Reply

Thanks for having this experience Wink This way I know to stay away from Kentmere. Plus, I find the Curse of the Third Roll (in my case, third and fourth) is pretty consistent. Psychological.


Reply

One thing in Kentmere's favor: It dries FLAT. I mean FLAT!
The developer, by the way, was Tmax, 5.5 minutes, 1-4, 68F.
Another good thing: look at the 3D effect in the lillies. Than again, it may have been that Franksteing lens: antique I-50 body, as-new optics unit from my i-50-2 ... Shocked Very Happy