Home

Please support mflenses.com if you need any graphic related work order it from us, click on above banner to order!

SearchSearch MemberlistMemberlist RegisterRegister ProfileProfile Log in to check your private messagesLog in to check your private messages Log inLog in

Step by step resassembly of the Ihagee original EXA - III
View previous topic :: View next topic  


PostPosted: Sat Aug 30, 2008 11:20 pm    Post subject: Step by step resassembly of the Ihagee original EXA - III Reply with quote

After some cleaning of all the debris and old lubricants, the reassembly follows the same steps in reverse, the final result look much cleaner than before:

#1 The shutter base looks clean, now the reassembly can start.



#2 Even the spacers look shiny.



#3 Install the left wing where the shutter lever goes.



#4 When placing this part, be careful of pressing the spring end behind





#5 Now place the shutter speed lever elements. There is a small spring wire that might be low of tension, adjust accordingly.





#6 Next place the shutter trigger lever and over it the mirror retainer.



Finally, place the two levers at the bottomside.
With this, we have again a working shutter mechanism.


Jes.


PostPosted: Sat Aug 30, 2008 11:26 pm    Post subject: Reply with quote

Wow! It is really clean! I can't wait for final result, how you can make from an orphan camera a new proud guy again!


PostPosted: Sat Aug 30, 2008 11:30 pm    Post subject: Reply with quote

We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


PostPosted: Sat Aug 30, 2008 11:31 pm    Post subject: Reply with quote

Laughing


PostPosted: Sun Aug 31, 2008 12:16 am    Post subject: Reply with quote

maddog10 wrote:
We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


Good name!. It will keep it Smile.

Jes.