MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

loose middle element-group Meyer-Optik Gorlitz 135mm 2.8
View previous topic :: View next topic  


Reply

(sorry, my previous attempt at this post didn't have a subject. Attempt number 2)

Hi, I recently purchased this nice lens. After I received it I heard some rattling.
I removed the front element, and found that the culprit was the large middle element. It's hanging loose and I can move it back and forth a few millimetres!
Only I can't figure out how to get access to it. I can't see a ring holding it in place and I need to get closer for a look.
Anyone know of instructions on deconstructing this lens?
Any help greatly appreciated. The rest is in very good shape so I'm hoping to get it up and running!
Pictures show exposed loose element




Reply

I started also disassembling the back end but didn't get any further than this. No idea how to proceed...



Reply

This is the M.O.G. 200 / 4 - possibly the same layout ?

This is the lens in bits.










I hope this makes sense. Wink


Reply

I'm almost there. No more time today. I will post some pictures when I'm finished. Thanks for the help.


Reply

Managed to get to the middle element, put the thing back together, and learned a lot along the way!
My first deconstruct Smile




Reply

Well done, it's a nice feeling to save such a nice lens. Very Happy


Reply

This is how it turned out.





Photographed with a recently purchased Pancolar 1.8/50mm


Reply

Congrats!


Reply

BobbyB wrote:
This is how it turned out.





Photographed with a recently purchased Pancolar 1.8/50mm

Hi Bobby just wondering if it was the same as the 200mm illustrated above to get into the middle element I have 2 of these with working apertures but very dusty inside.
The only lens I managed to clean is the flecktogon and it was very straightforward. I don't think this is going to be the same
Thanks for sharing
Badr


Reply

It's not a hard lens to work on. If you don't need to get at the blades then don't separate the two parts as shown in my pictures above. If the blades are oily and sticking, remove the glass and flush the blades and mechanism thoroughly with lighter fuel, use the whole can if it needs it - it's cheap.
The glass can be accessed without risking the aperture blades and is easy to get at. But - I dropped one of the inner lenses on to a plastic storage box lid from a height of about 6 inches and a huge piece of the lens broke off, I don't know if the glass is more brittle than other lenses or what caused it break, but I was very surprised.

The 135 and 200 are just about the same as well, my pictures should get you through either lens.


Reply

Lloydy
Thanks very much I will try and spare time to do it and update the thread


Reply

@Lloydy, @BobbyB

I have the same lens with broken aperture blades and I would like to repair it.
From your first picture, how did you do it to separate the lens in to two parts ?

Thanks