MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

my new version of power supply for gossen lunasix 3
View previous topic :: View next topic  


Reply



this is a new version
with less current consumption
i tested on my breadboard


Reply



Reply

visualopsins wrote:

lm317lz needs a minimun current in order to work
the current of lm317 in lz version is more low than a classic a lm317
you can supply this minimum current with the two resistors or with a load
with 82k and 100k trimmer and with no load ...it will increase the vout so it will be difficult in this case to have 2.7V with no load
i checked it with my breadboard


Reply

this is a new circuit
i built a circuit board with a dip8 socket
i am awaiting for the mcp6041-i/p..



Reply

metallaro1980 wrote:
visualopsins wrote:

lm317lz needs a minimun current in order to work
the current of lm317 in lz version is more low than a classic a lm317
you can supply this minimum current with the two resistors or with a load
with 82k and 100k trimmer and with no load ...it will increase the vout so it will be difficult in this case to have 2.7V with no load
i checked it with my breadboard


i built a little box and i putted inside the circuit board with mcp-6041 and a lithium 3.7 rechargeable battery 1200mA...current absorption is very little


Reply




Reply

it works up to 2.7V
in practice, across the diode voltage reference we have a voltage drop = 1.235V, and therefore also in the input of non-inverting op-amp.
it is a non-inverting op-amp circuit ...
the formula of vout is ...
vin+ * (1 + (feedback resistor or sum of feedback resistors / resistor or sum resistors ranging in mass)).
in this case
vin+ * (1+ (560.000 + 82000) / (470.000 + 0..100.000))....
now 2.7 / 1.235 ...2.186..
now ... 2.186 - 1 and we have 1.186 ... the total resistance feedback / total resistance ranging in mass must give 1.186
lt1004-1.2 is an updated version of lm385-1.2 with more accuracy and it works with a minimum current = 10uA.


Reply

Battery should last good long time @10uA! Nice work.

Now for some humor: