MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

"Skid" focus ring
View previous topic :: View next topic  


Reply

I have two lenses - Super Takumar 50/1.4 and Helios 44-M-4 58/2 that both have a "skid" focus ring.

It works like this: when you start rotating it slowly in either direction, it moves very loosely (like it is sliding without much resistance). After that, or if you rotate it faster, it will rotate smoothly and well-damped like nothing happened.

The most displeasing thing is when I need to focus carefully, I turn the ring very slowly and by a little distance forth and back. So instead of tactile confirmation I just get a feeling of loose focus ring.

My question is, can it be some physical wear in the helicoid threads, or maybe it just needs some new lubrication?
I don't know about Takumar, but I owned the Helios from the start and I can't say it went through much of wear.


Reply

That sounds like loose grub screws holding the focusing barrel connected to the helicoid. These screws run parallell to the lens, usually seen when removing the name/front ring of the lens. If they get really loose, the barrel will spin freely when turned. You can test if this is the case with your lens by pulling the focusing barrel towards the camera while turning it. This should cause the slipping to disappear (it has the same effect as tightening the screws).


Reply

If the focus is moving along with the ring as expected when it skips, then you need a lube job.


Reply

sceptic wrote:
You can test if this is the case with your lens by pulling the focusing barrel towards the camera while turning it. This should cause the slipping to disappear (it has the same effect as tightening the screws).


With the ring pulled to the camera the slip and non-slip part both gain more traction and became tighter, but the difference between them still exists.


Reply

I am not as experienced as many members here. However, in my limited experience, that sort of focusing issue has been related to a lubrication problem. I have seen it it German or Soviet lenses when the lubricant has gotten gunky. Cleaning out the old stuff and replacing it with a modern lubricant resolved the problem for me.