MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

Maco PO100C Orthopan stand developed in RO9
View previous topic :: View next topic  


Reply

I only had one roll of this film so I took the low-risk route of stand developing it in RO9 diluted 1:100 at 20C for 60 mins.

Due to a loading mistake, only 4 frames out of 8 were exposed and one of the four was a duplicate shot so there were only three frames.

Mamiya-Sekor 2.8/80 on Century Graphic 23. Was a dark, dull day. The film is a bit grainy for a 100 speed film (I exposed it at 80 as it was a few years expired) and the tonality is a bit flat in the midtones, not to my liking but it might be the development not being ideally suited to the film rather then the film itself which is to blame. Certainly the bad light played a role.

#1

#2

#3


Reply

I played with the curves a little to stretch the midtones a bit, which I think has improved them somewhat:





Reply

The subject matter in the 3rd shot is great. I really like rope dead center


Reply

Cheers. I like shooting there, I've posted quite a few 35mm shots from the same place, of the boats, the ropes and chains and other junk. I only made that one shot this time because it was so damn cold, the wind really roaring in off the Irish Sea, so it was a case of shoot them jump back in the car to warm up again. I made the same shot with four different film stocks as a test to see how they performed. This Maco one came out best as the other three were all over 30 years old and suffered sadly from heavy base fog. This is the ORWO NP15 one, much softer due to the base fog and I had to crop a bit off the left due to fogging.