MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

First test run with my B+W 1000x / 3.0 / 10-stop ND filter
View previous topic :: View next topic  


Reply

I ordered a B&W1000x / 3.0 / 10-stop ND filter last week, and it showed up Saturday. This afternoon was the first chance I got to get out and give it a try.

First off, a baseline test shot at 1/1000 sec (ISO 400 f/2.8, Nikon D600, Nikkor 17-35/2.8 AF-D) .



I then installed the filter and tried to let the on-camera filter take a light reading. It only changed 5 stops, so I kept going until I had counted off 10 full stops (1 second).



Still seemed a bit dark, especially after viewing the histograms. So I changed the shutter speed to 2 seconds, or a full 11 stops.



Both filtered shots show a striking lack of color vibrancy, but I knew there would be some issues to overcome.

Here's a 100% crop of both SOOC and 11x side-by-side:



These are just my 'preliminary' findings, and I was just shooting JPEGs to see what direction(s) I need to take. I'm sure with raw files, I'll be able to correct most, if not all, the lack of saturation and contrast.


Reply

Interesting, and what's the ultimate aim for this?


Reply

philslizzy wrote:
Interesting, and what's the ultimate aim for this?


Same reason anyone gets an ND filter.... to get longer shutter speeds.


Reply

There seems a change of white balance after you put the filter.


Reply

I have a similar metering issue with my variable Vivitar Series I ND 1000 filter. My camera only reads about half the needed exposure adjustment, so I find myself having to chimp a lot of shots with it. Also, I get the vignetting you experience past about 98% of the maximum setting. Interestingly, though, my ND filter dramatically intensifies color saturation, especially on the cooler end of the spectrum. The intensification I get is also proportional to how much of the variable setting I've used.

I assume yours is variable. If so, have you tried it on other settings than the max? If not, then nevermind.


Reply

OK, had some time this afternoon for some real testing. This time, things were a bit more controlled. And I tossed in my gray card for good measure. Taken at ISO 2000, 1/500. f/11, WB set to daylight (since I placed the WB card in the sunlight):




After installing the filter, and reducing the exposure 10-1/3 stops (that seems to give me a nearly identical histogram), I end up with this:




The first thing I noticed is it's quite warm. So I used the gray card to set the WB:



After the color correction, not only do I have a more natural-looking image (compared to the no-filter shot), it looks like the colors are a bit more saturated!

I'll do some more testing, but with these results, I think I'm gonna like having this filter in my arsenal!


Reply

480sparky wrote:
philslizzy wrote:
Interesting, and what's the ultimate aim for this?


Same reason anyone gets an ND filter.... to get longer shutter speeds.


Yes, I assumed that, but the photos posted didnt appear to benefit from it. I understand now you are getting the colour balance right before using it.


Reply

Even with TTL metering, the right way to use filters is:
1. Meter without the filter.
2. Mount the filter on the lens.
3. Compensate the exposure for the stops as reported by the filter.

Else, take the shot, and take another with exposure corrections applied.