MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

127 film cut from 120 rollfilm
View previous topic :: View next topic  


Reply

http://www.youtube.com/watch?v=o-HLR-k_qOE


Reply

all amazing ideas are the most simple.. as is this one:) thanks for sharing!


Reply

Sound idea!. Thanks for sharing Smile

Jes.


Reply

good idea, but how's he get it onto a 127 spool. I tried respooling 120 onto a 620 spool once and it was a nightmare


Reply

philslizzy wrote:
good idea, but how's he get it onto a 127 spool. I tried respooling 120 onto a 620 spool once and it was a nightmare


I think same night mare in darkness...

to 620 I simple clip a 120 roll with strong nail clipper, difference only between them 120 spool has larger diameter at ends.


Reply

Attila wrote:

I think same night mare in darkness...

to 620 I simple clip a 120 roll with strong nail clipper, difference only between them 120 spool has larger diameter at ends.


perhaps but its thicker in the middle too and the hole in the spool is smaller on a 620. However your nail clipper method works?


Reply

yes, works well in Kodak Monitor no issue.


Reply

Mark film a bit smaller 2mm at least than normal 127 due you can't cut perfectly. Do it in total dark, to be sure edges not get light. Start with cigar cutter , but finish it with sharp knife, cutter not cut straight well. Re-spool it to 127 spool.