MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

Minimizing Separation
View previous topic :: View next topic  


Reply

What storage factors (temperature, humidity, mechanical, other) for our lenses, if any, most influence and impact likelihood of lens separation (only).

I'm perfectly willing to accept that we, as MF (older) lens owners, don't have a lot of control over this unwanted outcome, if that's your view. But if you think we can exercise some control, if you think we can minimize separation likelihood, how is that accomplished?


Reply

I think the best policy is avoiding heat and high temperature changes in general. Also avoid pressure changes (air flights).


Reply

fermy wrote:
I think the best policy is avoiding heat and high temperature changes in general. Also avoid pressure changes (air flights).


I'm in accord with what you wrote. I should have thought of those things on my own . . but I didn't.

Still, after seeing your post I agree that it's changes in temperature and pressure that would act to weaken the bond between lenses which have been cemented together.

Thank you for helping me to think about this a new way.


Reply

fermy wrote:
Also avoid pressure changes (air flights).
can you explain this? I don´t think it´s a problem, pressure during flight is comparable to height of 2500-3500 meters above sea. That is like saying "don´t go to high mountains, the low pressure could harm your photo equipment" Shocked Cool


Reply

berraneck wrote:
fermy wrote:
Also avoid pressure changes (air flights).
can you explain this? I don´t think it´s a problem, pressure during flight is comparable to height of 2500-3500 meters above sea. That is like saying "don´t go to high mountains, the low pressure could harm your photo equipment" Shocked Cool


When you go to high mountings the pressure changes gradually. During the flight the pressure changes rapidly both on ascend and descent. My understanding is that rapid change of conditions is just as dangerous (if not more) for the stability of bond as excessive temperature/pressure. Sort of "it's not speed that kills, but a sudden stop".

I have only one lens with separation, I've noticed it after a flight in a very hot summer. I am not sure what was the primary cause though.