MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

1982 expired Ilford FP4 in Kodak Microdol-X
View previous topic :: View next topic  


Reply

Another test roll from an old bulk roll I bought, just to check the stock is still in usable condition. Konica FT-1 with Hexanon 1.7/50, 1:3 Microdol-X, 21mins, 24C, exposed at 50 ISO.

#1

#2

#3

#4

#5

#6

#7

#8

#9

#10


Reply

You got great success, #10 may best to me.


Reply

Thankyou. They vary a bit due to differing light, #10 was in direct light, some are in poor light so tonality suffers.


Reply

Ten looks very nice

The roll seems to be in good condition!


Reply

That must have been stored at or very near zero degrees Kelvin! The film doesn't give the results I would expect after 20 years. 7 and 10 are my standouts.


Reply

skida wrote:
That must have been stored at or very near zero degrees Kelvin! The film doesn't give the results I would expect after 20 years. 7 and 10 are my standouts.


I've got FP4 35mm bulk and 120 stored at room temp dated about 1982 and it's still ok...I dev some 120 last year after a gap of about 20 years and the results aren't too bad using promicrol, with better skill it would have been better

About 1982 FP4, RB67 taken in 2011


Reply

Thanks guys. I got lucky, the tin is rusty but was still sealed from the factory, no idea of storage but it does look like it's working fine. Not sure if it has lost any speed, I rate films at half speed for a broader tonal range and I think that would kinda mask any speed loss unless it was major. That's four old bulk rolls of FP4/FP4+ I've bought now, all worked fine. I bought a roll that turned out to be some mystery kodak and didn't work at all, no matter how much I exposed it and developed it I got very faint images but the clear letters 'Kodak Safety Film' on the edges, no identifying code, it seems to have lost all speed. I bought a roll of HP5 too and that is garbage, lost a couple of stops of speed and has a high base fog level so results are grainy and have ugly tonality. It's a bit of a gamble buying these old rolls, but I only buy if they are dirt cheap. Smile Now I have about 500ft of fp4/fp4+ to use, should keep me going a while. Just picked up a 100ft roll of 1997 expired tmax 100, need to try that next.