MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

Askania Rangefinder - adjusting
View previous topic :: View next topic  


Reply

Since a couple of week I purchased an Askania Rangefinder.





Soon I found out that the calibration was off because the messured distances where wrong. But unlike other rangefinders the Askania has no adjustmentscrew at the outside. So I opened the rangefinder to look for an adjustmentscrew on the inside, but apart from a screw to aline the vertical adjustment there was nothing else to be found.

When I looked through the finder of the dismanteld rangefinder to a subject at infinity and slightly pushed the brass mirrorholder (which is moved by the adjustmentwheel) I realized that the calibration was perfect at that moment. I decided to put a thin piece of paper between the brass mirrorholder and the "blind screw" of the adjustmentwheel. The result was perfect! Very Happy
After that I could just press the two halves of the rangefinder back together again.



Reply

I have a very similar Medis rangefinder and that is calibrated by a smll adjusting knob in the center of the main dial. I measure a distance, set the main dial to that, and then the tiny knob adjusts the rangefinder patch. The center knob is tight so it doesn't easily go out of adjustment.
Your picture looks as though there might be a similar arrangement on your Askania ?


Reply

These are typical instructions; however it is possible the Askania doesn't fit the mold. And at any rate sounds like you found a solution!


Photopia Rangefinder instructions by Nesster, on Flickr


Reply

The problem is that the round little "chrome" cover in the centre of the adjustmentwheel (which is probably hiding the adjustmentscrew) seems impossible to remove.



Reply

I think the center knob should turn - independently of the large adjuster - rather than be removed. I've just looked at a Watameter rangefinder and that is exactly the same.


Reply

Lloydy wrote:
I think the center knob should turn - independently of the large adjuster - rather than be removed. I've just looked at a Watameter rangefinder and that is exactly the same.

Sorry, it is impossible to turn nor seems it possible to remove.