MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

CZJ Sonnar 180mm/2.8 aperture problem
View previous topic :: View next topic  


Reply

Hello all! My first post here. I hope someone can help with a problem I'm having.

I just got a Carl Zeiss Jena Sonnar 180mm/2.8 lens in P6 mount, the all black MC version. It looks very nice with few signs of use but the aperture doesn't seem to close. Either that or I'm missing something. The lens has an A/M switch but not matter which position it's in the aperture doesn't move when I rotate the aperture ring or press in the aperture pin. It stays completely open at all times. Is there something obvious I missed or do you think the lens is broken? Should I take out my screwdrivers and go in? Has anyone service this lens before? Any instructions? Smile


Reply

The blades are probably just oily and stuck open. The mechanism/spring is fairly weak so it can overcome the stickiness of the oil on the thin blades.


Reply

Thanks. I thought that might be it but I've never had a lens that would have the blades completely stuck so I can't really tell what I'm looking at. Wink Do you think I'll need some special tools to disassemble this lens? Can I clean this oil off with ordinary dish washing detergent or will I need something better? Provided I can get to the aperture of course. I have disassembled a Sonnar before, but that was a 135/3.5 in M42 mount and I only needed to clean and relube the focusing ring. I'll google for some instructions, see if I can find something... Neutral


Reply

themoleman342 wrote:
The blades are probably just oily and stuck open. The mechanism/spring is fairly weak so it can overcome the stickiness of the oil on the thin blades.

+1 but don't think it will be easy. rather find a repair man.


Reply

Thanks for the advice but I was impatient and went for it myself. This lens is actually not that difficult to take parat (when you know how), at least to the level I needed. It turned out there wasn't any oil on the blades. Actually the lens looks like it has been cleaned and relubed recently but whoever did that, didn't put it back together quite right. One of the levers in the aperture mechanism was a little bit stuck, so that was a quick fix and all looked good again. Except then one of the tiny screws broke and I don't have another one (lesson: never overtighten any screws especially the really small ones) so I already thought I was going to be left with a very expensive paperweight. But I put the lens together without the auto aperture closing mechanism so until I find a replacement for that little screw, I'll have to do with only the M mode...


Reply

Agreed, the Sonnar MC 2,8/180 is quite easily disassembled. In fact, a lot of CZJ MC-version lenses just require the front and back lens group to be unscrewed, to reach the aperture blades for cleaning.