MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

What do you calla tool with two prongs? I need one
View previous topic :: View next topic  


Reply

Aaaarrggghhhh!

Just taken one of my Mamiya 135EE rangefinders for a walk, the one with the working selenium cell meter.

I get nearly home to find that the screw which holds the film advance lever in place has run away. I've walked about a mile so the chance of finding it is nil but have decided instead to take the part from the other one. The screw is wound down/up by means of a tool which locates two small prongs into holes in the top of the screw. Don't know where I'm going to find one, especially as I don't know what it'd be called...

any ideas guys?


Reply

I've used some unusual things that have done the job like:- two nails in a piece of wood and metal dividers (be careful of the sharp points)


Reply

I would try it first with a eraser / rubber, press firmly against the cap and twist. If that doesn't work use a small pair of engineers dividers - carefully. You might need to modify the tips of the dividers a bit to fit, use an oilstone. It's slower - more accurate - and will abrade the hard tips of the dividers, a file might not.


Reply

tikkathree wrote:
Aaaarrggghhhh!

Just taken one of my Mamiya 135EE rangefinders for a walk, the one with the working selenium cell meter.

I get nearly home to find that the screw which holds the film advance lever in place has run away. I've walked about a mile so the chance of finding it is nil but have decided instead to take the part from the other one. The screw is wound down/up by means of a tool which locates two small prongs into holes in the top of the screw. Don't know where I'm going to find one, especially as I don't know what it'd be called...

any ideas guys?


Try a hardware/automotive store, there are sets of "tamper-proof" defeating bits that include something similar -
http://www.amazon.com/Klein-32525-32-Piece-Tamperproof-Bit/dp/B0015S4JRG


Reply

The tool is called a spanner, and an adjustable spanner wrench is probably the tool you want to buy if you plan on disassembling cameras and lenses frequently. Personally I've found that I can usually make do with the tips of a vernier caliper.