MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

CZJ Tessar 2.8/50 disassembly
View previous topic :: View next topic  


Reply

I'm trying to repair my CZJ Tessar, but I can't find a proper tutorial as none of the repaired lenses in those tutorials seem to have been built like mine.
I only managed to remove the back and the focus ring and now I'm stuck.
Any advice on how should I proceed if I'm to disassemble it whole?

Here are the pictures:









I tried these advices, but none of them helped.

http://oomz.net/tessar/

http://forum.mflenses.com/how-to-tessar-disassembly-t30506.html

http://forum.mflenses.com/viewtopic.php?t=21037&view=previous


Reply

Hi,

If i remember well, you have to unscrew the front name ring to expose the notches that will allow you to unscrew the front optical group ...

Hope this helps ...


Reply

I saw your set on Flickr, but I'm not sure how does a sink cap apply on the front element (which is a bit different than mine).
Edit: I can actually move plastic "filter" just above the front lens glass,below the name plate, but it only moves till a certain point where it stops.


Reply

please look here:
http://forum.mflenses.com/how-to-put-my-czj-50-2-8-together-t23316.html
and here:
http://forum.mflenses.com/tessar-50mm-alu-reassembly-t11938.html


start to unscrew the ring at rear part.
(photo, in which you hold your tessar Wink )


Reply

I did it. Now I only have to reassemble it. Shocked


Reply

Fine, good news ...