MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

Pentacon 200mm f4 separated the cemented element
View previous topic :: View next topic  


Reply

Hello,

I recently opened a Pentacon for cleaning and while cleaning the lens elements, the two front cemented parts just separated maybe because of hot water used for cleaning (aprox. 40-50 deg centigrade).

What can be the loss if I don't re cement the elements optically speaking.
And if I want to re cement them what will I need?

Also another question: how to clean lenses and not get small dust particles inside ? No matter how well I blow dust away and use brushes there are still some small dust particles on the lenses.

Thanks.


Reply

sadness wrote:
Hello,

I recently opened a Pentacon for cleaning and while cleaning the lens elements, the two front cemented parts just separated maybe because of hot water used for cleaning (aprox. 40-50 deg centigrade).

What can be the loss if I don't re cement the elements optically speaking.
And if I want to re cement them what will I need?

Also another question: how to clean lenses and not get small dust particles inside ? No matter how well I blow dust away and use brushes there are still some small dust particles on the lenses.

Thanks.


erm why didn't you ask the forum how to clean lenses before you started.....re cementing elements together is a specialised job and not for ya average handy man.


Reply

Only really old lenses are cemented with Canada balsam and are heat separable. All polymer cements used since WWII are heat proof beyond the boiling point of water. So there must already have been something wrong with the cementing.

Home re-cementing is not really advisable - even less so when the lens has already separated so that you cannot make marks and templates to re-centre the lens to the old position mechanically (which you'd have to if you don't have the needed test equipment to centre it optically).


Reply

I followed many threads of repairing lenses and actually never seen that this could happen, especially on rather new lens I guess like this one, and this was not my first lens either.

Anyway I put it back together and here is a crop from a test picture, to me it doesn't look too different from what I have tested before, didn't have previous of the operation the oportunity to test it stoped down as blades were stuck.

100% crop @f4 - quite soft but not very different from before


Now stoped down seems ok but I might be wrong.