MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

High-end monitor suggestions
View previous topic :: View next topic  


Reply

I am considering of replacing my EIZO SX2461W.
It is an excellent monitor, but its PVA panel makes shadows to open up by about 1 stop when viewed under a 45º angle.

What would you suggest? At least 24".
EIZO has come up with a 24" (CG245W) which has a built-in (hardware) calibrator,
but I think it would be nice to move towards 30" (CG303W), to make the upgrade more "apparent".
I have also seen some very good NEC monitors, and considerably cheaper than EIZO.


Reply

I would put into consideration list also the HP Dreamcolor 2480zx

search reviews at prad.de


Reply

Get BARCO and calibrate it Smile well - if you're lucky - you may get a cool monitor for small momey - especially when some office/pre-press studio writes off some stuff..

tf


Reply

The last 3 monitors I've had have all been Samsung, who apparently make the actual lcd's for Sony.

If they do or not, I still like them.


Reply

I did not know about the updated 245, I would have picked the 243 if I were to buy a monitor today. Which means now, I will buy the 245 Smile

http://www.eizo.com/global/products/coloredge/cg243w/index.html


Reply

Barco Laughing

Since we can dream, also http://www.doubleblackimaging.com/products/c-3mp.htm


Reply

http://tftcentral.co.uk/ has very good monitor reviews. I would go for a NEC with a matched calibration device.

After having used an Apple ACD 30" for a long time, I am now on a Dell U2410. It's a nice screen, but I really needed to get used to the lower pixel pitch. It is a disadvantage for me, because everything looks a bit less sharp with the bigger pixels. If you don't have perfect vision, then the higher pixel pitch of a 27/30" screen might be a bit of a strain on your eyes.

I don't have any complaints about the Dell; it's a nice wide gamut screen with a good H-IPS panel from LG (practically the same panel as the HP LP2475W, which is usually more expensive). Only the black level could be a bit better perhaps, but it doesn't disturb me.

If you can afford one of the better NEC models, you'll get a more uniformly lit screen with less colour variation across the screen. For the price of a NEC or Eizo 24" you might be able to get two Dell U4210's though. Wink


Reply

ok -- if Barco is really expensive and not easy-to-get ..

I think one of the best pre-press monitors (excellent for Photoshoping)

is IIYAMA but the classic - CRT monitor ... I know it's huge but the outcome is excellent..

I have found one!!!! right now!!!!

Click here to see on Ebay

I would buy it!!! and it's in the UK... Smile

and this is consumer review - and believe me, it;s TRUE:

Advantages: pin sharp picture, flat screen, 3 year warranty
Disadvantages: tedious OSD navigation, the lines that come with an apeture grille will annoy a few
I had got myself burned badly with my first 17" monitor (I won't begin to tell you what happened - maybe another time). I decided I'd do it right this time.

I had always considered Iiyama to be high end monitors, a little out of my league, but as I was gathering information, I found that the Vison Master Pro 410 was more and more the monitor for me. I took the plunge and was not disappointed.

As soon as I got it out of the box, I knew this was a good piece of kit. It felt sturdy, it had dual inputs (D-SUB and BNC), and the screen was so flat, it actually looked concave comapred to other monitors I had seen before.

I hooked it up to my computer and went into Windows. Wow. The picture was sharp, pin sharp and rock solid. The colours were clear and bright. The regulation was excellent (notice the way the picture gets slightly bigger (nearer the edges of the tube) if there is a sudden change of brightness (like having a black background then opening a full screen, white window)? Monitors with poor regulation will show this up to a greater degree. The VM Pro 410 had virtually none of this.

The monitor comes with a three year swap out warranty.

It's not perfect. The OSD (On Screen Display) is controlled by only three buttons (menu, minus and plus) which make navigating a little tedious (example: to swap between the BNC and D-SUB inputs takes minimum 5 button presses). The visible area of the screen is only adequate, and the quite wide bezel surrounding the screen does a good job of making this monitor seem small for a 17".

This monitor has an aperture grille tube instead of a shadow mask. This uses a grille made up of lots of vertical thin wires to deflect the electron beam to make up the picture. Without getting too technical, to hold the wires together it is necessary to have 2 horizontal wires at 1 and 2 thirds down the screen. These are vaguely visible at all times, but you soon
forget that they are there. I never see them these days.

All in all, if I was to recommend a monitor manufacturer, I wouldn't hesitate to put Iiyama's name into the reckoning.



tf


Reply

If I was into buying CRT monitor, I´d pick Eizo T965 - i don´t about anything better, naturally except medical monitors and so. But it´s REALLY huge beast.


Reply

nkanellopoulos wrote:

EIZO has come up with a 24" (CG245W) which has a built-in (hardware) calibrator,


Panel is made by LG.


Reply

Himself wrote:
nkanellopoulos wrote:

EIZO has come up with a 24" (CG245W) which has a built-in (hardware) calibrator,


Panel is made by LG.

Your thought is vague.
You mean I should rather get an LG monitor?


Reply

My thought is not vague.
It's just an information.
How you use it, it's up to you.


Reply

Himself wrote:
My thought is not vague.
It's just an information.
How you use it, it's up to you.


You're not even making a point. It's not that important who is making the panel. Many manufacturers use LG panels, but the backlights and electronics used to drive and control the panel are very different. Lower end manufacturers like Dell/HP/Apple will not have a system to control the brightness and colour of different parts of the screen (to ensure homogeneity), like NEC (and Eizo probably too) has.


Reply

I would suggest a 30" screen. I have a DeLL at home and a Samsung at work, both very nice s-ips panels. It's a little weird the first day or two with all the extra space, but when you have tried 2560 x 1600 px screen you never want to go back to any smaller Wink