MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

Red Filter Question
View previous topic :: View next topic  


Reply

Hello Guys and Girls, I have searched forums, internet and also the Schneider website with no joy.

I have an old Schneider Optik filter labeled, (Med. Red No. 21/2). My question is what is the exposure compensation for this filter?

It appears to be two pieces of red glass and is very dark as opposed to a medium red, saying that the info on the box matches that on the filter rim.

I did think about running off some test shots making notes of various compensation values as I went, and checking them against the results. A bit of a long winded approach I thought. I even thought about emailing Schneider direct for an answer, but as I'm an avid follower of this forum I thought I would put you knowledgeable folk to the test.

Its also a good excuse for me to finally sign up to this forum. Wink


Reply

Don't know about Schneider but Vivitar's deep red cuts light by four stops.

Can't you use auto metering with and without it to see what your camera thinks?


Reply

Nowadays, medium red is not that strong, and needs around two or three stops. However "medium red" 30's style was pretty deep red, old film sheets have it at five to eight stop. But modern film has more red sensitivity, and the filter may have faded, so the old figures are meaningless today. You'll have to establish your own figures - do a test roll, with your preferred film on critical subjects (outdoor with foliage both in sun and overcast, and indoor/tungsten) and 2-6 stop exposure compensation each.


Reply

Thanks Paul, now why didn't I think of that. Hahaha!

The filter fits my older M42 lenses but with the adaptor ring on my 350d should do the trick.

Will post up the result just in case someone else comes across the same filter.

Thanks again Paul Wink


Reply

Sorry Sevo, I didn't see your post till now.

It is 8 - 9 stops compensation Servo you was right at the top end.

Thanks for your help. I guess I shall be using it with a tripod then. Laughing


Reply

The exact amount of compensation also depends on the film, the light, and the effect one wishes to achieve with the photo. For example, the Ilford SFX-200 film has greatly extended red sensitivity without actually being a true infrared film; such a filter would probably require little to no compensation on that film.

Last edited by Arkku on Sun Mar 21, 2010 7:12 pm; edited 1 time in total


Reply

Thank you Arkku, I was not aware of this. I will have to experiment more with different films and do some extra research.

Thank you again Very Happy


Reply

My rule of thumb tends to be 3 stops for red, 2 for orange and 1 for yellow. Different films tend to more or less influenced, but for negative films this seems to work for me. One way is to take a light reading holding the filter over the meter.

Red filters are a bit extreme in terms of effect.