| View previous topic :: View next topic |
| Author |
Message |
Kathmandu
 Joined: 09 Dec 2009 Posts: 1479 Location: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posted: Wed Dec 09, 2009 6:27 pm Post subject: Steinheil Culminar 85mm f2.8 dissasembly, Done with this TY |
|
 Posted: Wed Dec 09, 2009 6:27 pm Post subject: Steinheil Culminar 85mm f2.8 dissasembly, Done with this TY |
|
|
Kathmandu wrote:
Hi everyone,
I have come to own a Steinheil Culminar 85mmf2.8. I bought this with haze and aperture residue marks thinking I would clean it. I have the lens open from the back and have the rear lens element out. I don't seem to be able to get beyond that- I have used more than reasonable force so far, I did not want to use any more force than necessary.
I am hoping to be able to open the front lens element, that would be my best point of access to clean. I have tried the rubber drain plug to twist the front preset label to no avail.
I have all the screws on the side unscrewed ~and have looked everywhere for information- no luck. My mind hurts from thinking of possible ways to take the front cell off.
Any suggestions or links would be of great value- to me.
Thank you 
Last edited by Kathmandu on Sun Dec 13, 2009 5:11 am; edited 1 time in total |
|
| Back to top |
|
 |
Attila
 Joined: 24 Feb 2007 Posts: 58002
Expire: 2025-11-18
|
 Posted: Wed Dec 09, 2009 7:30 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 7:30 pm Post subject: |
|
|
Attila wrote:
Welcome!
Little nasty lens I did open one times it takes more than 4 hrs to assembly back. It has plastic aperture holder inside and lot of small screw. Unfortunately I don't know any assembly diagram, hopefully somebody able to help you. |
|
| Back to top |
|
 |
Kathmandu
 Joined: 09 Dec 2009 Posts: 1479 Location: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posted: Wed Dec 09, 2009 8:08 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 8:08 pm Post subject: |
|
|
Kathmandu wrote:
Thank you, luckily I will not have to get to the iris or mess with the aperture blades-they look intact and operate smoothly. I just need to find a way to access through the front to remove the front lens, and clean behind it . Nice forum Attilla. |
|
| Back to top |
|
 |
Attila
 Joined: 24 Feb 2007 Posts: 58002
Expire: 2025-11-18
|
 Posted: Wed Dec 09, 2009 8:24 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 8:24 pm Post subject: |
|
|
Attila wrote:
if rubber not work another practice drill two small hole two front ring and you can remove it with spanner wrench. This is last solution if anything else not works. |
|
| Back to top |
|
 |
Kathmandu
 Joined: 09 Dec 2009 Posts: 1479 Location: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posted: Wed Dec 09, 2009 10:03 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 10:03 pm Post subject: |
|
|
Kathmandu wrote:
So the nameplate does come off, is that right? It looked to me like the nameplate and piece on the front barrell is one piece. |
|
| Back to top |
|
 |
Attila
 Joined: 24 Feb 2007 Posts: 58002
Expire: 2025-11-18
|
 Posted: Wed Dec 09, 2009 10:12 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 10:12 pm Post subject: |
|
|
Attila wrote:
| Kathmandu wrote: |
| So the nameplate does come off, is that right? It looked to me like the nameplate and piece on the front barrell is one piece. |
Must be come off perhaps I am wrong and one piece I did opened mine 3 yrs before. |
|
| Back to top |
|
 |
Kathmandu
 Joined: 09 Dec 2009 Posts: 1479 Location: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posted: Wed Dec 09, 2009 10:21 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 10:21 pm Post subject: |
|
|
Kathmandu wrote:
Thanks for jogging your memory back- I dont mean to have you revisit your nightmare again but here is what is looks like~I am sure you knew. |
|
| Back to top |
|
 |
Kathmandu
 Joined: 09 Dec 2009 Posts: 1479 Location: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posted: Wed Dec 09, 2009 10:25 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 10:25 pm Post subject: |
|
|
Kathmandu wrote:
 |
|
| Back to top |
|
 |
Kathmandu
 Joined: 09 Dec 2009 Posts: 1479 Location: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posted: Wed Dec 09, 2009 10:30 pm Post subject: |
|
 Posted: Wed Dec 09, 2009 10:30 pm Post subject: |
|
|
Kathmandu wrote:
I am taking off to go see the birds and the trees for now~I appreciate your time Attila. If that nightmare picture jogs your memory of how you opened it up ~I would be happy to know.
I was at your ebay page- I love that lens spanner tool you have there-looks solid and beautiful . Its sucks that shipping is so much to the US .
Regards |
|
| Back to top |
|
 |
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|