MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

oil on the blades
View previous topic :: View next topic  


Reply

1. Oil on the blades is always bad news and very risky situation for fungus in the future.

2. Oil on the blades is not always bad news, in fact it is very good news for the preset lenses.


The truth?


Reply

#2 is correct.

Don't know about #1 but oily blades on anything else than a preset is bad as the aperture will be sluggish at best or even jammed.


Reply

Depend from makers in my experience, on Russian lenses normal doesn't make any problems.

On Japanese lenses not normal and depend from your luck aperture will stop working.


Reply

IMO neither - oil on the blades is fungus neutral, but it indicates either excess oil (often from a careless repair, where it might be a telltale sign of other flaws), or a migration of decomposing factory lubes. It will, as the oil accumulates dirt and oxidizes, eventually cause the blades to stick (which takes a long time to become fatal on preset lenses). And if it is a secondary symptom of oil migration or decomposition from/at lubed bearings, other parts of the lens are at risk as well.


Reply

Personally, (and I don't know for sure, if it's true!!!), I think most "oil on the aperture blades" problems are caused the camera/lens being left in a place that can get very hot (e.g. in a car, at about 70 degrees celcius, or just in the hot sun), with the lens on its side. I suspect that many greases will probably start to flow a little bit when the lens gets this hot.