MFlenses - A new life in a digital age
MFLenses 2026

Manual Focus Lenses Forum

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.

Explore the world of vintage lenses through repair notes, real test shots, and detailed archive threads packed with images.
Spotlight

Featured partner placement for the forum front page.

Yashica Electro GSN back door
View previous topic :: View next topic  


Reply

I finally found the time - and a suitable state of mind - to fix my Electro GSN with a faulty exposure meter. When I had opened it - and desoldered the flash sync wires to get the top off completely, I checked the POD and surprise - it was as new. White, hard rubber or plastic. completely intact. I just cleaned some contacts I saw inside - and the exposure lights were lighting up as they should and the shutter seems to work up to 15 seconds at least. Very Happy

I had some difficulties to solder the flash sync wires back again, but now the camera is in one piece, waiting for light seal replacement. I have a Jon Goodman kit, it should be rather simple, I hope.

But here´s my question: when I close the back door, there´s definite play on the upper latch side corner. I removed all old light seal materials, but the play didn´t go away. Is the door faulty or crooked, or is this normal?


Reply

My that sounds like some horrible bowel condition - but seriously...

I have 3 Elecro models, two tightened up completely when seals replaced, one had a problem similar to yours, which oddly stopped manifesting whenever a film was put in! Whether the film meant the latch / latch slot joint was under tension and thus 'stiffer' I do not know... none of the three shows any fogging though... Smile

I'd suggest you put a film canister in and see if the problem disappears? Might just work, it did for me...

All the best, Happy 2009!

Doug.


Reply

Thank you Doug. I´ll try with a film. Very Happy