Home

Please support mflenses.com if you need any graphic related work order it from us, click on above banner to order!

SearchSearch MemberlistMemberlist RegisterRegister ProfileProfile Log in to check your private messagesLog in to check your private messages Log inLog in

Primotar 50/3.5 maximum aperture
View previous topic :: View next topic  


PostPosted: Mon Jan 12, 2015 7:58 pm    Post subject: Primotar 50/3.5 maximum aperture Reply with quote

I have a question about the maximum aperture of my Meyer Primotar 50/3.5, M42 mount serial 1988794.

It has an aperture pin and switch for manual and auto mode.
With the aperture set at f/3.5, in either manual mode and auto mode with the aperture pin pressed, in the aperture blades slightly close.

When the aperture is set to f/4 the blades don't really close further.


Is this normal?


PostPosted: Mon Jan 12, 2015 9:43 pm    Post subject: Reply with quote

half stop not move count as normal, especially on auto lenses, even a little dust on blades make it , never mind, if works anyway, enjoy.


PostPosted: Tue Jan 13, 2015 4:04 am    Post subject: Reply with quote

Yes, Attila is right - nothing to worry about.
I have the pre-set version and even though the max aperture is listed on the lens as f3.5, it does actually open a little wider than that.
Setting the aperture to f3.5 from the wide open position closed it just a little...... and only a little more for f4
The difference between the two is very slight.
Even wide open it is still quite a good lens
OH